HYPERCRETE PLUS M is polycarboxylic ether based advanced superplasticizer which is specially developed for workability retention of low slump concrete. The product could be used for virtually any type of ready mix concreting where the slump retention is important.
HYPERCRETE PLUS M is compatible with all types of cements and other mineral admixtures.
HYPERCRETE PLUS M is free of chlorides and meets the requirements of ASTM C494 Type G5075, BSEN 934-2
Sulfonic groups of Naphthalene or Melamine based admixtures which adsorbed on to the cement particles induce a negative charge and repulse each other and increase the workability. With a similar mechanism, but unlike sulfonic
groups, the lateral chains of the main polymer of polycarboxylic ether induce a steric hindrance with strong repulsive force which in turn increase the workability of the cement paste.
Colour: Clear to Pale Yellow
Specific Gravity: 1.07 ± 0.02
Dosage: 0.6 lit to 1.5 lit / 100kg
Product Base: polycarboxylic ether
pH Value: 4-5
SPECIAL ADVANTAGES
- Well researched and developed product to be used with manufacturing sand , HYPERCRETE PLUS M enhances the softness of the concrete and extremely resistant to bleeding and segregation
- High Initial Workability compaired to Hypercrete plus
- Stable Slump
- Higher Concrete Density
- Higher Strength
- Low air Content
ADVANTAGES
- Well researched and developed product to be used with manufacturing sand , HYPERCRETE PLUS M enhances the softness of the concrete and extremely resistant to bleeding and segregation
- Longer slump retention for any slump or flow concrete
- No bleeding & segregation.
- Reduce shrinkage and creep.
- Reduces porosity and hence permeability of hardened concrete.
- Rheoplasticity leads to a densely compacted durable concrete at hardened state.
- Esthetically attractive surface texture and sound finish.
- Very high water reduction and thereby low permeability and shrinkage.
- Less pumping pressure and ease of pumping.
- Helps in hot weather concreting
COMPATIBILITY
HYPERCRETE PLUS M is compatible with mineral admixtures such as Silica Fumes, FlyAsh, GGBFS and chemical admixtures such as waterproofing admixture, Air entraining agents and corrosion inhibiting agents. HYPERCRETE
PLUS M is compatible with lignosulphonate based admixtures and not compatible with naphthalene admixtures. .
DIRECTIONS FOR USE
HYPERCRETE PLUS M should be dispensed into the pre measured total water quantity. This helps the admixture to be mixed homogeneously in the concrete. It should not come into contact with dry cement or other admixture until they are mixed in the concrete. Agitate the liquid well prior to use
DOSAGE
The optimum dosage should be determined by site trials with particular raw materials. As a guide HYPERCRETE PLUS M is normally used at a dosage 600m1 to 1500m1 per l00kg of cement.
However for specific requirements dosages outside the above could be used.
PACKAGING AND STORAGE
HYPERCRETE PLUS M is supplied in 205L drums, 1000L IBC tanks or in bulks tankers of 2400 L.
HYPERCRETE PLUS M has a shelf life of 12months in its unopened drums.
SAFETY OF HANDLING
HYPERCRETE PLUS M does not contain any hazardous chemicals and nontoxic. But it is recommended that safety glows are used in handling the product.
TECHNICAL SERVICE
The company provides good servicing from a team of dedicated specialists in the field. When used in accordance with its current published directions, the product will perform as described in this catalogue. Millennium Concrete Technologies will
not be responsible for difficulties caused by other materials, conditions or inferior workmanship and quality control. We reserve the right to determine the true cause of any difficulty by accepted test methods.
